•Open the web interface by entering 192.168.2.150 (or the IP address set on the MovingCap) in the address bar.
TIP: If you do not know the IP address that has been set (anymore), you can find it out via the LED display.
•Select the Back & Forth function in the Click & Run menu.
The drive starts oscillating over the distance specified by Target Distance (Move Rel).
NOTE: For the Back & Forth and Move Relative functions, the reference position is normally the last internal target position. This also applies if the previous movement was interrupted before reaching its target, for example by Stop Motion. When position control is activated, or when the drive enters the Operation Enabled state, the internal target position is initialized to the current actual position for position option code 60F2h.0h = ...0h. Therefore, the first positioning command after activation should normally specify an absolute target position.
